AirGuard 100 Installation Guide

Tools Required:

• Drill
• Screwdriver (appropriate for mounting screws)
• Level
• Measuring tape
• Pencil
• Wrench (if needed for hose clamps)
• Safety glasses
• Gloves

Package Contents:

• AirGuard 100 unit
• Mounting brackets and hardware
• Rubber hose (Single Door or Double Door Kit)
• Hose connectors
• User manual

Safety Warnings: 

• Always wear safety glasses and gloves during installation.
• Ensure the power outlet is turned OFF before starting any electrical connections.
• Follow all local electrical codes.
• If you are not comfortable with electrical work, consult a qualified electrician.
• Keep children and pets away from the installation area.

Installation Steps: 

• Plan the Layout:

  • Determine the mounting location for the AirGuard 100 unit. It should be close to a power outlet and the area you want to clean.
  • Plan the routing of the rubber hose along the doorway or area.
  • Ensure the hose will not obstruct the door's movement.

• Mount the AirGuard 100 Unit:

  • Use the mounting brackets as a template to mark the screw holes on the wall.
  • Use a level to ensure the brackets are straight.
  • Drill pilot holes.
  • Attach the mounting brackets to the wall.
  • Mount the AirGuard 100 unit onto the brackets.

• Connect the Rubber Hose:

  • Attach the hose connectors to the AirGuard 100 unit's outlets.
  • Attach the rubber hose to the connectors.
  • If using the Single Door Kit, route the 8-foot hose along the desired area.
  • If using the Double Door Kit, route the 18-foot hose to cover both sides of the door.
  • Use hose clamps to secure the hose if necessary.
  • Attach the right-angle connector at the bottom of the hose, near the floor.

• Connect the Vacuum Cleaner:

  • Ensure your vacuum cleaner is turned OFF.
  • Connect the vacuum cleaner's hose to the appropriate inlet on the AirGuard 100 unit.
  • Make sure the connection is secure.

• Electrical Connection:

  • Ensure the power outlet is turned OFF.
  • Plug the AirGuard 100 unit into the power outlet.

• Test the System:

  • Turn ON the power outlet.
  • Turn ON your vacuum cleaner.
  • Adjust the AirGuard 100's speed control knob to achieve the desired airflow.
  • Test the system by opening and closing the door to ensure proper cleaning.

• Final Adjustments:

  • Make any necessary adjustments to the hose position or speed control.
  • Ensure all connections are secure.

Important Notes: 

• The AirGuard 100 relies on the blowing power of your vacuum cleaner. Ensure your vacuum has sufficient airflow.
• Do not restrict airflow through the hose, as this can damage your vacuum cleaner.